Mendota FV-41 Specifications download pdf (Page 33)

33 | Page

FV-41 DOOR OPERATION

TO REMOVE DOOR

1. Use the glass latch tool to disconnect the spring latches from the glass frame. Insert tool into hole in latch,

pull towards you and Rotate 90 degrees to disengage top latches. Remove tool. There are two spring

latches on top of this gas fireplace.

2. With both hands, rotate top edge of glass frame away from unit 12 inches.

3. Lift glass frame up 1 inch, at an angle, and move away from unit.

4. Door is now free from unit.

TO REPLACE DOOR

1. Line up the three bottom tabs in glass frame bottom with slots in glass clips on firebox bottom. Insert

tabs into slots and center tabs in slots, left to right.

2. Center Glass Frame over Firebox; left to right.

3. After door has been placed into slots, rotate door towards firebox until gasket seal is touching the firebox

frame.

4. Use the tool provided to connect the spring latches to the glass frame. Insert tool into hole in spring

latch, pull latch towards you, rotate latch so the hook is facing downward then release latch to hook to

door frame.

5. Door is now connected and sealed to unit.

The following Check-Off Lists must be completed prior to final operation of the Fireplace.

2.) PULL

3.) ROTATE

4.) RELEASE

1.) INSERT

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

No comments

Mendota FV-41 Specifications Page 33