INSTALLATION & OPERATING INSTRUCTIONS Full View Direct Vent Gas Fireplace Insert With Premium Texture Fiber Logs Combustion System MODEL #E
Part #85-03-00855 9 Chimney Flashing and cap (See FIGURE BELOW) The vent kits include a trim-able flashing. Measure, trim and shape flashing to fit
Part #85-03-00855 10 14. Remove the Vent Adapter by removing two 5/16” Hex Bolts and sliding Vent Adapter to-wards rear of Insert. 15. Tightly sec
Part #85-03-00855 11 18. You are now ready to hook up the Insert to gas supply. Be sure gas plumbing instructions and all state and local codes ha
Part #85-03-00855 12 sert, the existing and approved hearth protection will provide adequate floor protection. If a raised hearth extends less than
Part #85-03-00855 13 GAS PRESSURE CHECKING REQUIREMENTS A pressure tap for checking gas pressure is located on the main gas valve. A qualified insta
Part #85-03-00855 14 GAS PRESSURE REQUIREMENTS One major cause of operating problems with gas appliances can be improper gas pressure! Such problems
Part #85-03-00855 15 HIGH ALTITUDE INSTALLATIONS For installations from 610-1370 meters (2000-4500 ft.) the orifice sizes (DMS) for natural gas are
Part #85-03-00855 16 INSTALLATION CHECK OFF LIST The following check list must be completed prior to initial lighting of the Fireplace Insert, or ma
Part #85-03-00855 17 2.) PULL3.) ROTATE4.) RELEASE1.) INSERTDOOR REMOVAL AND REPLACEMENT CAUTION: Do not operate the appliance with glass removed,
Part #85-03-00855 18 FV-44i LOG SET INSTALLATION INSTRUCTIONS FOLLOW EACH STEP DEPICTED IN THE DIAGRAMS, BELOW, TO INSTALL THE LOG SET. CAUTION: LOGS
Part #85-03-00855 1 TABLE OF CONTENTS SPECIFICATIONS ...
Part #85-03-00855 19
Part #85-03-00855 20
Part #85-03-00855 21
Part #85-03-00855 22
Part #85-03-00855 23
Part #85-03-00855 24
Part #85-03-00855 25
Part #85-03-00855 26
Part #85-03-00855 27 PLACE SMALL COALS ON TOP OF FLOOR BRICK PANELS AND CLOSE TO GRATE BOTTOM TO SIMULATE A COAL BED.
Part #85-03-00855 28 BEFORE YOU BEGIN Read this entire manual before you use your new fireplace insert(especially the section “Safety Precautions”).
Part #85-03-00855 2 SPECIFICATIONS MODEL E-FV-44i High Fire - Adj. to - Low Fire BTUH ...NAT
Part #85-03-00855 29 REMOTE TRANSMITTER OPERATING INSTRUCTIONS TO TURN ON THE APPLIANCE: 1. Press the ON/OFF button. The transmitter display will
Part #85-03-00855 30 MANUAL BYPASS OF THE REMOTE SYSTEM If the remote transmitter is misplaced or lost, the appliance can be turned on manually by s
Part #85-03-00855 31 “FIRST TIME” PILOT LIGHTING INSTRUCTIONS IMPORTANT: Be sure all items on "INSTALLATION CHECK OFF LIST" in the Install
Part #85-03-00855 32 ATTENTION! The transmitter and receiver are RADIO FREQUENCY DEVICES. Placing the receiver in or near metal may severely reduce
Part #85-03-00855 33 FV-44i GAS IGNITION SYSTEM WIRING DIAGRAM
Part #85-03-00855 34 MAINTENANCE 1. ANNUAL MAINTENANCE OF MENDOTA UNITS IS REQUIRED. The following procedures must be performed each year by a Mend
Part #85-03-00855 35 5554LP Pilot Orifice[#977.168]MotorizedLP PressureRegulator[10.0-5.5"WC]# 907.012Burner Orifices#65-14-00054[54 DRILL]#65-1
Part #85-03-00855 36 Use an Alan WrenchTo loosen and removeNG Pilot Orifice. InstallLP Pilot Orifice, TightenDown.Pull Pilot Hood UPand lift UP off t
Part #85-03-00855 37 LP PRESSURE REGULATOR CONVERSION INSTRUCTIONS WARNING: Failure to position the parts in accordance with these diagrams or failur
Part #85-03-00855 38 LP GAS PRESSURE REQUIREMENTS Inlet and manifold gas pressure checking taps are located on gas valve. These ports are only access
Part #85-03-00855 3 SAFETY AND WARNING INFORMATION READ and UNDERSTAND all instructions carefully before starting the appliance. FAILURE TO FOLLOW th
Part #85-03-00855 39 WARNING DO NOT PROCEED WITH OPERATION OF THIS FIREPLACE UNLESS BURNER "CYCLES" ON/OFF WITHOUT DELAYS! CHECKING FOR NO
Part #85-03-00855 40 GAS INLETGAS SHUTOFF CONTROLGAS SHUTOFF CONTROLROTATE TO CLOSEHOLE FORTOOLTIP INDICATESVALVE ORIENTATION EMERGENCY GAS SHUTOFF C
Part #85-03-00855 41 CUSTOMER INFORMATION AND TROUBLE-SHOOTING OVER FIRING/UNDER FIRING OF BURNER NEVER "over fire" units by adjusting gas
Part #85-03-00855 42 GAS FLAME ADJUSTMENT During the initial installation, the air shutter opening should be checked to be certain that the shutter
Part #85-03-00855 43 Replacement and Service Parts Note: Glass replacement is to be done by ordering the complete Glass Frame assembly #HA-58-00029.
Part #85-03-00855 44 MENDOTA WARRANTY QUALIFICATION & SERVICE REFERENCE FORM As a part of Mendota's on-going program of customer satisfacti
Part #85-03-00855 45 TAPE SHUT --------------------------------------------------------------------------------------------------
Part #85-03-00855 46 MENDOTA EXTENDED LIFETIME PROTECTION AND LIMITED WARRANTY MENDOTA GAS FIREPLACE INSERT MODEL: FV-44i NAT. & L.P. Mendot
Johnson Gas Appliance Company 520 E Avenue N.W. - Cedar Rapids, IA 52405 Website: www.johnsongas.com or www.mendotahearth.com
Part #85-03-00855 4 CONGRATULATIONS You are the owner of a world-class heat producing gas direct vent sealed combustion fireplace. This elegant, high
Part #85-03-00855 5 GENERAL INFORMATION Your Mendota Gas Fireplace Insert has a state-of-the-art direct vent, sealed combustion system. This advan
Part #85-03-00855 6 MENDOTA FV-44i GAS DIRECT VENT FIREPLACE INSERT SPECIFICATIONS & CLEARANCES FV-44i Faceplate Dimensions A B Inches
Part #85-03-00855 7 INSTALLATION INSTRUCTIONS CAUTION: Each installation must conform to all local, state and national codes. Refer to the national
Part #85-03-00855 8 FLUE VENTING The FV-44i Insert must be vented vertically to the outside and must use the Mendota Co-Linear flexible ducting syste
Comments to this Manuals