Mendota E-FV44I ECHO SERIES Operations Instructions download pdf (Page 36)

Part #85-03-00855

LP Pilot Orifice

[#977.168]

Motorized

LP Pressure

Regulator

[10.0-5.5"WC]

# 907.012

Burner Orifices

#65-14-00054[54 DRILL]

#65-14-00055[55 DRILL]

NATURAL TO LP GAS CONVERSION

Kit # HA-58-00302 for Mendota Model FV-44i

This conversion kit shall be installed by a qualified service

agency in accordance with the manufacturer’s instructions

and all applicable codes and requirements of the authority

having jurisdiction. If the information in these instructions is

not followed exactly, a fire, explosion or production of car-

bon monoxide may result causing property damage, per-

sonal injury or loss of life. The qualified service agency is

responsible for the proper installation of this kit. The instal-

lation is not proper and complete until the operation of the

converted appliance is checked as specified in the owner

instructions supplied with the kit.

Caution: The electrical supply to the fireplace must be

turned off prior to performing the conversion. The gas

supply must be shut off prior to disconnecting the electrical

power.

ORIFICE SIZES REQUIREMENT

A Natural Gas to LPG conversion kit #HA-58-00302 must be ordered and installed to convert the FV-44i Fireplace to burn

LPG.

LP Conversion Kit # HA-58-00302 contains the following parts: One Motorized LP Pressure Regulator #907.012, One LP

Pilot Orifice Thimble #977.168, and two Cap Orifices (drill #55).

Recommended Procedure to Convert This Fireplace To Burn LPG

This Fireplace Insert arrives from the factory ready to burn Natural Gas. If you intend to burn LPG, it is highly recommended that you

convert this fireplace and its Pressure Regulator, Pilot Orifice Thimble and Burner Orifices prior to placing this fireplace in its fire-

place cavity.

See diagrams, on this page, and follow these instructions to prepare this fireplace for conversion to LPG.

1. Using a ¼” Hex Driver, remove 4 screws that secure the Log Grate in place. Remove Grate from Firebox.

2. Remove the Floor Brick Panels by lifting them out of the firebox.

3. Remove the left-side access panel mounted to the left outer skin and lay down gently without disconnecting any wires of internal

components.

REMOVE SCREWS

FIRST.

REMOVE LOG GRATE

FLOOR PANELS

LIFT UP AND

REMOVE

FLOOR PANELS

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comments to this Manuals

No comments

Mendota E-FV44I ECHO SERIES Operations Instructions Page 36

Comments to this Manuals

Related products and manuals for Fireplaces Mendota E-FV44I ECHO SERIES